How Do You Fix a Lawn Mower Pull Cord: Easy DIY Guide
Introduction
Fixing a lawn mower pull cord is simple. Anyone can do it. You don’t need special skills. You only need a few tools. Let’s get started.
Credit: www.youtube.com
Tools You Will Need
- Screwdriver
- Wrench
- New pull cord
- Gloves
Step-by-Step Guide
Step 1: Safety First
Always put safety first. Wear gloves to protect your hands. Make sure the lawn mower is off. Disconnect the spark plug. This will prevent the mower from starting.
Step 2: Remove The Starter Housing
Find the starter housing. It is on the top of the mower. Use a screwdriver to remove the screws. Keep the screws in a safe place. Lift off the starter housing.
Step 3: Remove The Old Cord
Look inside the starter housing. Find the old pull cord. It is usually worn out or broken. Remove the old cord carefully. Note how it is attached.
Step 4: Prepare The New Cord
Take the new pull cord. Measure it to the same length as the old one. Cut the new cord to size. Melt the ends with a lighter to prevent fraying.
Step 5: Attach The New Cord
Insert one end of the new cord into the starter housing. Tie a knot at the end. Make sure the knot is secure. Wind the cord around the pulley. Follow the same path as the old cord.
Step 6: Reassemble The Starter Housing
Place the starter housing back on the mower. Align it properly. Secure it with screws. Make sure all screws are tight.
Step 7: Test The Pull Cord
Reconnect the spark plug. Try pulling the cord. It should move smoothly. If it does, you have done a great job.
Tips for Maintenance
- Check the pull cord regularly.
- Replace worn cords immediately.
- Keep the starter housing clean.
- Store the mower in a dry place.
Credit: www.tiktok.com
Frequently Asked Questions
How Do I Replace A Lawn Mower Pull Cord?
First, remove the cover. Replace the damaged cord. Rewind the new cord. Test the pull.
Why Does My Lawn Mower Pull Cord Get Stuck?
Debris or grass can cause jams. Also, damaged recoil springs or tangled cords can be the issue.
What Tools Are Needed To Fix A Pull Cord?
You need a screwdriver, pliers, and a replacement pull cord. Sometimes, a wrench is needed.
How Do I Rewind A Lawn Mower Pull Cord?
Hold the cord. Rotate the pulley counter-clockwise. Release slowly. Ensure cord tension is correct.
Can I Fix A Pull Cord Without Professional Help?
Yes, it’s often a simple fix. Follow steps carefully. Use basic tools. Ensure safety.
How Often Should I Check My Pull Cord?
Check before each mowing season. Inspect for frays or damage. Replace if necessary to ensure smooth operation.
Conclusion
Fixing a lawn mower pull cord is not hard. Follow these steps. Use the right tools. Soon your mower will work again. Good luck!
